crude rapeseed oil refinery equipment,1tpd-30tpd crude oil refinery equipment manufacturer with engineer service

sunflower seed oil planting equipment Application of sunflower seed oil deodorization plant / vegetable oil refinery equipment.This units crude rapeseed oil refinery equipment,1tpd-30tpd crude oil refinery equipment manufacturer with engineer service belongs to sunflower seed oil deodorization plant / vegetable oil refinery equipment, has all functions of large, small scale intermittent refining equipment, and better than them. This equipment crude rapeseed oil refinery equipment,1tpd-30tpd crude oil refinery equipment manufacturer with engineer service can make high quality cooking oil or salad oil. This units complete set combined, selfprepare heat source, gas source, electrics control. Light weight, save electricity , convenient use.This sunflower seed oil deodorization plant / vegetable oil refinery equipment do not need special basis, either indoor or outdoor is OK, just need to make up power source, water, prepare coal, alkali, Pacid, active clay, edible salt and other material.

crude rapeseed oil refinery equipment

The characters of crude rapeseed oil refinery equipment :

The simple paremeter of crude rapeseed oil refinery equipment:

The system of crude rapeseed oil refinery equipment :

Brief introduction for crude rapeseed oil refinery equipment:

(1).P-acid degumming operation:

Drawing the filtered or settled crude oil into the neutral pot, control oil temperature 40 ° C, liquid level cover the neutral pot volume about 80 %.Add into the neutral pot P-acid with 85% concentration, 0.1-0.2% oil weight.Start up neutral pot, make main shalf stirring at 60-70 r/min, finish de-gumming in 30 min.

(2)alkali de-acid operation:

After finish de-gumming process, at once add into lye carrying alkali refining de-acid, lye concentration 16 ° Be ′, super alkali is 0.1-0.3% oil weight, af-ter finish adding, continuous stirring 30min, when soap particles accumulated condensing, should reduce stirring speed, 30r/min avoid emulsion. After adding alkali, gradually rising temp to the end temp 65 ° C, see to that the rising temp speed should control at 1 degree per minute, not too fast. Shut off neutral pot drive part, the oil settled in the pot 6-8 hours, make oil separate from soap.

(3)water rinse operation :

Adjust the neutral pot oil temp to about 85 ° C, add into hot water whose temp higher oil temp 10-15° C, the water use amount each time is 10-15% oil weight.Start neutral pot drive part, make the main shalf stirring washing at 30r/min, make the oil and water fully contact, stirring time 5-10 min.If oil/soap separate not ideal, the oil contains relative high left soap, the first time washing, better to use thin salt water evenly spray into oil.

(4).de-coloring:

After dehydrate, inhale 3-5% oil weight active clay into the de-color pot to carry absorb de-coloring. Decolor pot main axis stirring speed 60r/min, time 20 min, vacuum degree 750mmHg, is the whole absorb de-color craft process requirement. Shut off vacuum valve, open vacuum break valve, stirring non-stop, reduce the oil temp down to 70 ° C, the de-color finished.Continuous stirring, open oil outlet valve, press the de-color oil into the Press filter, filter away waste clay, the last use air compressor blow clean and dry

(5).De-odor operation:

Open the vacuum valve, make the pot inside vacuum degree gradually reach above 750mmHg.Inhale the de-color oil after filter into the de-odor pot, see to that oil amount should cover the pot volume 60% Control oil temp at 240 ° C - 260 ° C, use the direct steam under 0.1 -0.3Mpa to distillate 3-4 hours.Shut off steam, shut off heat source, when the oil temp cooling to below 80 ° C, shut off vacuum, release de-odor oil , the de-odor process has finished.

crude rapeseed oil refinery equipment :

After finish degumming process about crude rapeseed oil refinery equipment,1tpd-30tpd crude oil refinery equipment manufacturer with engineer service, at once add into lye carrying alkali refining deacid, lye concentration 16 ° Be ′, super alkali is 0.1to0.3% oil weight, after finish adding, continuous stirring 30min, when soap particles accumulated condensing, should reduce stirring speed, 30r/min avoid emulsion. After adding alkali, gradually rising temp to the end temp 65 ° C, see to that the rising temp speed should control at 1 degree per minute, not too fast. Shut off neutral pot drive part, theoil settled in the pot 6-8 hours, make oilseparate from soap.

If you have any demand about microwave drying equipment and edible oil refining equipment, pls feel free contact us any time.
Email:sales21@ldfoodmachine.com
Whatsapp:+86 13064099546
Skype:leaderfoodmachine21
Contact:Mandy

NOTE:We can specially design the machine according to your production's features.